K6S
- Will fit internal hammer versions
- Non rubber grips will NOT fit exposed hammer versions (DASA)
- Available in G10 and rubber
- G-10 grips are a 2 piece design with a screw through the middle. Included with the grip are 2 pins, these fit in the holes at the front of the grip.
- To install G-10 grips, remove current grip, insert the 2 included pins in one side of the grip and set onto grip frame, set remaining grip panel onto the grip frame matching up the frame pin and the included pins, attach both grips together with the screw through the middle.
K6S DA/SA
- This is a 6 shot stainless steel revolver.
- Will fit only models with the exposed hammer.