King Cobra & Anaconda
King Cobra and Anaconda
- Colt King Cobra and Anaconda revolvers have the same grip frame so the grips are interchangeable and have an open backstrap.
- Will fit Kodiak
- Will fit Trooper MK IV and MK V
- Does not fit the MK III. (look under Colt MK III for this model).
- Will NOT fit Cobra, only King Cobra. Look under Colt Detective special for the Cobra.
WARNING!!
Colt re-introduced a model called the King Cobra in 2017. For the New King Cobra please select the Cobra/King Cobra Small Frame grips.
Hogue grips for these guns are the one-piece Monogrip design. They are ambidextrous allowing both right and left handed use. Installation is simple requiring the stock grip pin be removed and the stirrup to be snapped in place. The grip then slides up from the butt, with one screw securing the grip through the butt. All necessary hardware is provided. The stirrup pin goes through the center of the frame, NOT through the hole that the stock pin came out of.
Rubber grips have a speedloader cutout on the left of the frame and have our logo on the right side. Wood grips are cut out identical on both sides.
Because of the protruding pins at the top of the frame it is normal to see a small hole on both sides on wood grips only. Rubber grips flex around these pins.
NEW PRODUCTION 2017+ King Cobra, Cobra, Viper
- New Production "D" Frame models produced 2017 and later
- 48000 Detective Special Rubber Grip will fit these new models
- 47X80, 47X81 King Cobra and Anaconda wood grips will fit these models.
- Fits the following NEW PRODUCTION Models (Any Barrel Length):
- Cobra
- King Cobra Target .22/.357
- King Cobra
- King Cobra Carry DAO
- King Cobra Carry
- Viper
NEW PRODUCTION 2022+ Python, Anaconda, Kodiak, Grizzly
- New Production "I" Frames
- Fits 46xxx grips, Rubber and Wood Python Model
- Fits the following NEW PRODUCTION Models(Any Barrel Length)
- Python
- Python Combat Elite
- Target Python
- Anaconda
- Target Anaconda
- Kodiak
- Grizzly