K and L Frame Square Butt
-
Fits the following Smith and Wesson K/L Frame Square Butt Models:
11, 16, 18, 45, 48, 53, 56, 68, 581, 648 - the following models are either Round or Square Butts:
10, 12, 13, 14, 15, 17, 19, 64, 65, 66, 67, 547, 586, 617, 681, 686 - To differentiate between Round and Square Butt, Measure the flat area on the very bottom of your grip. This is the surface that commonly has the serial number located on it. Round butts will measure under 1 ¼” and Square butts will be over 1 ¼”.
- Hogue grips for Smith & Wesson revolvers are the one-piece Monogrip design. They are ambidextrous allowing both right and left handed use. Installation is easy requiring the stirrup to be simply snapped over the existing stock pin. The grip then slides up from the butt, with one screw securing the grip through the butt. All necessary hardware is provided.
- This grip is an open backstrap design for optimum trigger reach.
- Some rubber and nylon grips have a "speedloader" cut out on one side only - Wood grips are cut out on both sides